Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Technical instructions
2. Technical features
Sizes
Installation
Power supply
Power consumed
Max. luminous flux
LED type
Protection index
3. Installation
Different kind of installation are available for Mini Brio 2 M12 & X12 : in 2'' wall inlet (for concrete pool) with PF10R294
bezel and adapter or in CCEI 1.5'' wall inlet for one-piece pool (PF10R291) or liner pool (PF10R292). The installation should
be performed by a professional.
3.1. Electrical connection
Installation of this product involves a hazard of electric shocks. We strongly recommend you
contract a professional installer. Incorrect installation places you in danger and may irre-
versibly damage the product and the equipment connected to it. In compliance with the NF C
15-100 standard, pool lights installed in Volume 0 must always be powered with SELV (Safety
Extra Low Voltage). Always cut off the power upstream before handling the electrical instal-
lation.
Risk of electric shock. Only connect to a circuit which is protected by a ground-fault circuit
interrupter. If you are not sure if these types of devices are fitted, contact a qualified electrician.
3.2. Installation into a threaded 2'' wall conduit (with PF10R294)
Mini Brio 2 M12 & X12
Only in a threaded 1.5" inlet ref. PF10R291 (one-piece pool) or PF10R292 (liner)
12W (X12 RGBW version) - 900 lm (according to colour)
Take into consideration the total number of lights to select the right 12V (100 / 300VA)
The electrical connection must be performed dry, in a sealed
connection box whose cable glands must be tightened in order
to avoid any water infiltration.
1. Screw the light in the 1,5" adapter then pass the cable
2. Push and screw it thoroughly
2" wall conduit (with bezel ref PF10R294)
12W (M12 and M12Kversion) - 1200 lm
Risk group 1 (low risk) according to IEC62471:2006
though the wall conduit
v1.0ML
Ø 49mm / depth : 63mm
12V ~ (AC) 50Hz/60Hz
transformer
IP-68
2
Publicité
Chapitres
Table des Matières
