Appliance Specifications - Joycare JC-330 Manuel D'utilisation

APPLIANCE SPECIFICATIONS

1- Steam mask for the facial sauna of your entire face
2 -On-off switch and power indicator light
3- Valve to adjust steam flow
4- Measure
INSTRUCTIONS FOR CORRECT USE
This appliance is intended only for use on people's faces. The use of the facial sauna is an excellent base for facial beauty treatment. The face's skin is prepared
in an optimal way to receive further treatments, e.g. deep cleaning, hydration, application of face masks etc. Beauty salons very often begin facial treatment
with steam treatment. The steam, which acts as a stimulant, increases circulation to the skin, opens the pores and allows better removal of impurities.
This is an excellent starting point for any type of facial treatment. Beauty products penetrate the skin deeply through the pores, thereby optimizing their
effectiveness.
USING THE APPLIANCE
Place the appliance on a flat and stable surface that is not sensitive to water. Pour 30 ml of water into the appliance's water tank using the measure. Do not
exceed the maximum fill level. Never fill the water tank directly under a tap, but only with the help of the measure provided. Do not use oils, herbs or other
plants instead of water.
Unwind the cable completely. Insert the plug into the socket. Then turn the product on using the on / off switch and the red pilot light is lit. After a few
seconds steam will start to rise.
It is possible to adjust the steam flow using the valve located inside the facial mask
Now position yourself in front of the appliance. Bend forward until your face is above the mask. If you feel that the steam is too hot, increase your distance
from the appliance to avoid scalding.
If you want to end the treatment or when the water has evaporated, turn off the switch. The pilot light will switch off.
After use wait about 5 minute and then rinse your face with cold water, then apply cream or a face mask. The opening of the pores allows active ingredients
to deeply penetrate your skin. We recommend no more than 2-3 sessions per week.
Warning: During treatment do not keep your face too close to the mask, as a strong intensity of the steam can cause scalding.
CARE AND MAINTENANCE OF THE APPLIANCE
Always unplug the appliance before emptying the water tank. Never pull the plug out of the socket by pulling on the power cable or with wet hands.
Allow the appliance to cool down and then drain the remaining liquid from the container. Take overall care to ensure that no liquid enters the appliance
7