Engine - Yamaha YP20G Manuel Du Propriétaire

Engine

1. Remove the spark plug, pour about one table-
spoon of engine oil (See page 19) into spark plug
hole and reinstall the spark plug. Recoil start the
engine by turning over several times (with ignition
off) to coat the cylinder walls with oil.
2. Pull the recoil starter until you feel compression.
Then stop pulling. (This prevents the cylinder and
valves from rusting.)
3. Remove the water drain plug and drain the water.
Reinstall the water drain plug after drained the
water.
4. Clean exterior of the water pump and apply a rust
inhibitor.
5. Store the water pump in a dry, well-ventilated
place, with the cover placed over it.
6. The water pump must remain in a vertical position
when stored, carried or operated.
– 29 –