TRENDnet TEW-455APBO Guide D'installation Rapide page 20

I typed http://192.168.10.100 in my Internet Browser's Address Bar, but an error message
says "The page cannot be displayed." How can I get into the TEW-455APB0's Browser
configuration page?
1. Check your hardware settings again by following the instructions in section 2.
2. Make sure the LAN, WLAN and PWR LEDs are lit.
3. Make sure the TCP/IP settings are configured properly.
4. Since the Access Point's default IP address is 192.168.10.100, make sure that no
other network devices are assigned an IP address of 192.168.10.100.
5. The IP address may have changed. Reset the TEW-455APBO to return all settings to
factory default. To reset the TEW-455APBO, see the above troubleshooting question.
If my network's IP is different than the Access Point's range, what should I do?
You should still configure the Access Point first. After all the settings are applied, go to the
Access Point's configuration page, click on IP settings and change the IP address of the
Access Point to match your network's IP.
After I successfully configured the Access Point to match my network settings, I can not
connect to my network using wireless computers.
If you have a DHCP server in your network, you need to go into TCP/IP settings again and re-
select "Obtain an IP address automatically" to allow the PC to regain an IP address from your
DHCP server.
All the settings are correct, but I can not make a wireless connection to the Access Point.
1. Double check that the WLAN light on the Access Point is lit.
2. Power cycle the Access Point. Disconnect the Ethernet cable that is connected to the
P+DATA OUT port. Wait 15 seconds, then plug the power back in.
3. Contact the manufacturer of your Wireless Network Adapter. Make sure the Wireless
Network Adapter is configured with the proper SSID. The default SSID of the Access Point
is TRENDnet455APB00.
If you still encounter problems or have any questions regarding the TEW-455APBO, please contact
TRENDnet's Technical Support Department.
82