Nice E FIT MHT 1517 Instructions Et Avertissements Pour L'installation Et L'utilisation page 9

After about 10 seconds, the motor performs a number of movements equal to the number impulses given with the transmitter.
04. (on the new transmitter) Press the same key as you pressed in point 01 and hold it down while the motor performs 3 movements. Upon completion, release the
key. Warning! If the motor performs 6 movements, it means that its memory is full.
01 example
New
03
Old
04 same
01
New
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.10 - Memorisation of a climate sensor connected via radio
To perform the procedure you must have a transmitter ("old") already memorised in "Mode 1".
Before starting the procedure, bring the awning to the midpoint of its stroke.
01. (on the climate sensor) Keep the yellow key pressed for 10 seconds and then release it (in this case the motor does not perform any movement).
02. (on the old transmitter) Give for 3 pulse to the n key, provided it has already been memorized.
03. (on the climate sensor) Keep the yellow key pressed for 2 seconds: the motor performs 3 movements to confirm the memorisation. Warning! If the motor per-
forms 6 movements, it means that its memory is full.
01
Note – When performing the procedure, at any time you can cancel it by keeping the n and t keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
02
8
sec.
Old
x 1 = Ste-by-Step
x 2 = Open > Stop > ...
x 3 = Close > Stop > ...
0,5
sec.
x 4 = Stop
3
5
sec.
02
"P1" "P1"
1 0
sec.
Old
4
5
sec.
1 /
2 /
3 /
?
10
sec.
4 /
03
X 3
0,5
sec.
"P1"
3
2
sec.
English – 8