APLIC 302614 Manuel De L'utilisateur page 22

3 Product details
4 Commissioning
Take the device and the accessory out of the package and remove all the packa-
ging material. Charge the barcode scanner fully before using it for the first time.
For this, connect the RJ45 to the USB cable via the RJ-45 connector with the bar-
code scanner and plug the USB connector into a free USB port of your computer
or into a 5 V USB power adapter. To remove the cable at the bottom of the bar-
code scanner, press the latch of the RJ-45 connector downwards and disengage
the cable. To operate the device, the USB receiver must be connected to a free
port of your computer, notebook or tablet. The driver is installed automatically.
The device is now ready to be used. For advanced settings, continue with chapter
"6 Advanced Settings".
Note: the barcode scanner works only when the USB receiver is plugged in.
The charging cable is only meant for charging the device.
5 Scanning angle
To ensure correct scanning, make sure that the scanner is not held at a 90° angle
to the barcode. The scanner has to be pointed towards the bar code and the
laser should cover the entire barcode. If this is not the case, errors might occur.
22
Status LED
Sensor unit
Trigger
Wireless receiver
RJ45 connector
English