PCM GSC1310-HP-II Mode D'emploi page 2

English
1. To fix the tool holder to the machine,
introduce the shank and then tighten
the 4 screws of fixations (Important,
watch that the screws have the
same strength of tightening).
2. Adjust the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSC1310-HP-II
3. During the mounting or the dismounting
4. The tool shank diameter should
MARK :
-
-
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation :
27.05.2021
of your tools, block the broach on flats
planned for that purpose, using an
adapted wrench.
never have a difference of more than
0.4 mm compared to the clamping
diameter of collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
Never use the tool holder with empty
positions. Use the supplied
protection plug.
Never use the tool holder without
the internal coolant.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email: office@pcm.ch
Document :
GSC1310-HP-II
Mode d'emploi.docx
Page : 2 de 4