Texas Equipment Power Split 720V Manuel De L'utilisateur page 13

Recommended hydraulic oil
We recommend the following oil to the
hydraulic cylinder (Oil is refilled on delivery!):
Texamatic 7045, viscosity 33,8. Art. no. 90306479.
Or oil with corresponding viscosity
Operation
The log splitter may only be used by one person!
Recommended size of logs to be split
Recommended size of logs are diameters from 8 to 35 cm.
The diameter of the log is only indicative. A small piece of
wood can be difficult to split if it has knots or if its fibres are
very tough. A larger piece of wood can be split if its fibres are
smooth and loose.
Never force the log splitter to split more than 5 seconds with
the cylinder under pressure in order to split excessively hard
wood. Overheated oil under pressure may damage the
machine. It is very important that if the log splitter does not
split in the first attempt, please stop the machine and rotate
the log 90 degrees. If the wood still cannot be split, it means
that the hardness of the wood exceeds the capacity of the
machine and it must be rejected in order not to damage the
log splitter.
When splitting both handles shall be used
as shown on picture.
Variable splitting length from 25-50 cm.
Height is adjusted by pushing down both handles (vertically)
to the requested size of wood. Here you let go of one of the
handles. Loosen the knurled nut (shown) and the bar
indicating the height is pulled up and the
knurled nut is refastened (shown).
Picture 12
Transport
Transport the machine while the log splitter is in a horizontal
position.
The strap can fasten the handles during transport.
Storage
The log splitter is to be stored in a vertical position.
PLEASE READ THE FOLLOWING CAREFULLY
ALL REPAIRS AND REPLACEMENTS MUST BE CARRIED
OUT BY AN AUTHORIZED DEALER AND NOT BY THE
PURCHASER. THE PURCHASER ASSUMES ALL RISKS
AND LIABLILITIES ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT OF PARTS THERETO OR INSTALLATION
OF THESE.
Due to continued product development Texas A/S reserves
the right to improve the product without improving already
sold models.
Warranty terms and conditions
The warranty period is 2 years for private end users in EU
countries.
Products sold for commercial use, only have a warranty
period of 1 year.
The warranty covers material and/or fabrication faults.
Restrictions and requirements
Normal wear and replacement of wearing parts are NOT
covered by the warranty.
Wearing parts, which are NOT covered for more than 12
months.
The warranty does NOT cover damages/faults caused
by:
•
Lack of service and maintenance
•
Structural changes
•
Exposure to unusual external conditions
•
Damages to the bodywork, deck, handles, panels etc.
•
If the machine has been improperly used or overloaded
•
Use of unoriginal spare parts.
•
Other conditions where Texas cannot be held
responsible.
Whether a case is a warranty claim or not is determined in
each case by an authorized service center.
Your receipt is your warranty note, why it should always be
kept safe.
REMEMBER: The purchase of spare parts as well as any
request for warranty repair, art. no. (e.g. 90052XXX), year
and serial number should always be informed. It can be
found on the CE-label on the machine!
* We reserve the right to change the conditions and accept
no liability for any misprints
13