Bestway 58500 Manuel D'utilisation page 13

FIRST TIME USE INSTRUCTIONS
Backwash and Rinsing must be performed to
prepare the pump for its first use and to wash the
sand.
CAUTION: DO NOT DRY RUN THE SAND FILTER
1. Press down on the Control Valve handle and rotate to the Backwash
function.
2. Plug in and run the sand filter for 3-5 minutes, or until the water runs
clear.
3. Switch off the sand filter and set the Control Valve to the Rinse
function.
4. Switch on the sand filter and run the sand filter for 1 min. This
circulates water backwards through the sand filter and drains water
out Port D.
5. Switch off the sand filter. Set the Control Valve to the Closed function.
6. Top up pool water if required.
IMPORTANT:
you'll need to replace.
Switch off the sand filter immediately if water levels near the pool's Inlet
and Outlet valves.
1. Now the sand filter is ready for use. Set the Control Valve
to the Filter function.
NOTE: To prevent the risk of electrical shock dry any excess
water from yourself and the sand filter.
IMPORTANT: Before operation, make sure the tank is
placed steadily on its base and connected correctly to the
pump.
2. Switch on the sand filter to run it.
NOTE: The sand filter has now started its
filtering cycle. Check that water is returning
to the pool and take note of the filter
pressure on Pressure Gauge. Generally, the
recommended sand filter pressure is less
than 0.56 Bar (8.0 PSI) when it is running.
This procedure removes water from the pool, which
13
Backwash
10
15
5
23
0
psi
bar
Rinsing
20