Publicité
Troubleshooting
[GB]
Please read this section to troubleshoot any problem before requesting repair services.
Trouble
No dry air blown when hands put in.
Dryer not stopped when hands removed
No warm air blows
The air volume is weak
Water stands in the waste pan stopper
If the problem still persists after performing suggested actions, turn off the power switch and set the breaker to "Off."
Then consult with the installation contractor (or the shop where you purchased the unit). (See the back cover of this manual for contact details.)
10
Solutions
● Power Switch might be set to OFF.
→If so, set Power Switch to ON. (See page 5)
● Has the Circuit Breaker ON been tripped?
→If it is OFF, please reset it.
● Is there any obstruction in the waste pan ?
→ If there is any obstruction, please remove it.
● Is the sensor dirty?
→If the sensor is not clean, wipe it with a soft damp cloth. (See page 8)
● Is there any obstruction in the waste pan ?
→ If there is any obstruction, please remove it.
● Is the sensor dirty?
→If the sensor is not clean, wipe it with a soft damp cloth. (See page 8)
● Heater Power Switch might be set to OFF.
→If so, set Heater Power Switch to ON. (See page 5)
● Has Filter accumulated dust or debris?
→Clean Filter if there is an accumulation of dust or debris
(See page 9).
● Is the drainage hole clogged with dirt?
→ In case the drainage hole is clogged, clean it with a cotton swab
or toothpick (See page 8).
[GB]
Indicators
Status indicator lights
Always On
ON
OFF
LED
Flashes once
ON
OFF
LED
Flashes twice
ON
OFF
LED
Meaning of the indicators
Operation of the product/Corrective actions
Power is being supplied
An indicator is lit dimly all the time.
(Standby)
Sensors keep malfunctioning
The dryer may operate even if some sensors
malfunction.
Verify that sensors are clean. If they are not
clean, wipe them with a damp micro fibre cloth.
( See page 8)
If the indicator does not turn off after
performing these actions, consult with the
installation contractor (or the shop where you
bought the unit).
The dryer is not working.
Fan motor is malfunctioning
Clean the filter if it is dirty. ( See page 9)
Clean the bottom of the unit if it is dirty.
Thermistor is malfunctioning
Abnormality with the power
The dryer is not working.
terminal block temperature fuse
Replacing it may solve the problem.
Consult with the installation contractor
Controller is malfunctioning
(or the shop where you bought the unit).
11
Publicité
