Sommaire des Matières pour monitowoc Garland Master Serie
- Page 1 Master Series Infra-Red & Ceramic Broilers Installation, Operation and Maintenance Manual models M60XR M60XRC M60XS M60XT M100XR M100XRC M100XS M100XT M110XM Original Instructions Part # 4515576 Rev 2 (01/15/16)
-
Page 2: Important Information
IMPORTANT INFORMATION WARNING: This product contains chemicals known to the state of California to cause cancer and/or birth defects or other reproductive harm. Installation and servicing of this product could expose you to airborne particles of glass wool/ceramic fibers. Inhalation of airborne particles of glass wool/ceramic fibers is known to the state of California to cause cancer. -
Page 3: Table Des Matières
TABLE OF CONTENTS IMPORTANT INFORMATION......... . 2 SPECIFICATIONS . -
Page 4: Specifications
SPECIFICATIONS Technical Specifi cations Model Designations MINIMUM SUPPLY MANIFOLD Model Broiler Burner Base PRESSURE OPERATING PRESSURE Number Natural Gas: 7” w.c. Natural Gas: 6” w.c. M60XR Cast Iron Burner With Standard Oven Propane: 11” w.c. Propane: 10” w.c. Ceramic Tile M60XRC Cast Iron Burner With Convection Oven... -
Page 5: General Information
GENERAL INFORMATION 1. Check crate for possible damage sustained during transit. 4. The type of gas and supply pressure that the equipment Carefully remove unit from crate and again check for was set-up for at the factory is noted on the data plate damage. -
Page 6: Installation
INSTALLATION Siting At locations where the manual isolation valve is fi tted or the automatic system can be reset, a notice MUST be fi tted The fl oor on which the appliance is to be sited must be stating: capable of adequately supporting the weight of the “ALL DOWNSTREAM BURNER AND PILOT VALVES MUST appliance and any ancillary equipment. -
Page 7: Installing Ceramic Radiants (Model M60Xr)
INSTALLATION Continued Installing Ceramic Radiants (model M60XR) 2. The front casters on the appliance are equipped with brakes to limit the movement of the appliance without placing any strain on the connector or quick-disconnect device or its associated piping. 3. Please be aware that the required restraint is attached to a bracket (which is located on the rear caster closest to the gas connection) and if disconnection of the restraint is necessary, be sure to reconnect the device after the... -
Page 8: Fdo Heavy Duty Oven Control
INSTALLATION Continued 7. Shut off all valves and set thermostat dials to “OFF” or clockwise to decrease, or counter-clockwise to increase lowest position. the fl ame on the burner to the lowest possible stable fl ame. When properly adjusted, the by-pass fl ames will All units are tested and adjusted at the factory, however, cover the entire length of the burner. -
Page 9: Operation
OPERATION These special burners operate in a manner similar to that Broiler Section of a conventional gas burner except that the radiation Cast Iron Burner With Ceramic Tile - M60X surfaces consist of a series of ceramic blocks each containing numerous small gas ports. -
Page 10: Ovens
OPERATION Continued CAUTION: Should burner ignition fail within 5 seconds, Convection Ovens (RC) turn the burner valve off and repeat steps 1 through 5. If Lighting: ignition continues to fail, consult your factory authorized service agency. Same as standard oven. Ovens Start-Up: Standard Ovens... -
Page 11: Product Application
PRODUCT APPLICATION Broiler It is suggested that all products be dipped in salt-free oil before broiling to facilitate browning and to aid in The following information is intended for use as a guide. preventing the product from sticking to the broiler rack. There are many variables that will eff ect the operation. -
Page 12: Care & Cleaning
PRODUCT APPLICATION Continued Center the load on the oven racks to allow for proper heat When rethermalizing frozen products, preheat the oven 50°F circulation around the sides. The oven will hold three, 18” x (10°C), higher than the cooking temperature to compensate 26”... -
Page 13: M110Xm
CARE & CLEANING Continued Remove and clean the grid rack inserts and grease drip chute Instructions For Removal Of Grid Rack & daily. Pull the grid rack forward and lift the grease rack insert Grid Rack Frame out of the frame. Remove the grease drip chute by pulling it forward out of the rack frame guides. -
Page 14: Wiring Diagram
WIRING DIAGRAM Page 14 Part # 4515576 Rev 2 (01/15/16) - Page 15 Notes Part # 4515576 Rev 2 (01/15/16) Page 15...
- Page 16 GARLAND 1177 KAMATO ROAD, MISSISSAUGA, ONTARIO, CANADA, L4W1X4 888-442-7526 WWW.GARLAND-GROUP.COM Every new piece of Manitowoc Foodservice equipment comes with KitchenCare™ and you choose the level of service that meets your operational needs from one restaurant to multiple locations. StarCare – Warranty & lifetime service, certifi ed OEM parts, global parts inventory, performance audited ExtraCare —...