Technical Specifications - VGE Blue lagoon UV-C Copper Ionizer B200012 Notice D'utilisation

TECHNICAL SPECIFICATIONS

EN
• Lamp TUV UV-C
• Swimming pool content (L)
• Recommended max. flow
• Maximum copper
• Maximum pressure
• Maximum temperature
• Minimum temperature
• Connection size
• Length of the device
SIX STEPS FOR A PERFECT SWIMMING POOL WHEN USING AN IONIZER
1. Shock
When your pool is new, filter your water and give it a 'shock' of 2 ppm chlorine.
2. Balance
Your pool should have a pH balance of between 7.0 and 7.6, tested weekly.
3. Total alkalinity
The ideal values are between 100 and 200 mg/l CaCO₃. Correct alkalinity can generally be
achieved through sufficient back-flushing of the filter. This refreshes the water.
4. Calcium hardness
The ideal value is between 5 and 10 °dH.
5. Installing your Ionizer
Install your Ionizer as described in the instructions for use.
6. Copper level (0.4 – 0.7 ppm)
Set your Ionizer so that the copper level remains within the ideal range of 0.4 to 0.7 ppm. You
can test this with the supplied test strips.
8 |
For the safety instructions and terms of guarantee we would like to
refer to the general UV-C manual from VGE International B.V.
40,000 L 75,000 L
40 Watt 75 Wattt
40,000 l 75,000 l
23,000 l/h 23,000 l/h
0.7 ppm 0.7 ppm
2 bar 2 bar
50°C 50°C
0°C 0°C
Ø 63 mm Ø 63 mm
100 cm 100 cm