Victron energy BMV Manuel page 8

3. Using the BEI
After the wires are connected to the BEI, it can be powered
up.
3.1 E-plex bus
Whenever there is communication on the E-plex bus, the
status LED will blink. When there is much communication it
will look like LED is on all the time.
When used with the Victron ViewTouch, no user configuration
is required. However, the BEI can also be used with other E-
plex control modules such as the 400ECM, 450ECM and
500CCM (for more information see:
http://www.e-plex.co). When using the BEI with other control
modules, additional configuration is necessary.
3.2 Using the BEI with control modules
other than the Victron ViewTouch
To use the E-plex bus you need the E-logic software to
program it. If you do not have this it can be downloaded from:
http://www.e-plex.co
Or contact your dealer.
3.2.1 E-logic software
E-logic is used to design your system using schematic entry.
This manual will only describe the BEI object. For more
information on the E-logic software or other E-plex interfaces
refer to the documentation of the software of the device.
4