Toyotomi Zibro LC-SL530 Manuel D'utilisation page 23

THE USE OF THE MOTION DETECTION SENSOR
This heater is e uipped
the front side of the heater and it signals every single movement. The motion
detection sensor has a hori ontal detection angle of 80 and a vertical detection
angle of 20 . The sensor detects movements as far as 7 m.
If the sensor does not detect movements for 10 minutes then the heater will
automatically s itch to a lo er combustion level. As a result less fuel
SWITCH ON THE MOTION DETECTION SENSOR
S itching on the motion detection sensor can only be done
turned on. Push the "Motion" button L. A signal
light will light up (green).
If the sensor does not detect movements for 10 minutes then the heater will
automatically switch to a lower combustion level. The motion detection sensor
light keeps lighted up. If the sensor detects movement the motion light will blink.
The heater switches back to the latest temperature setting.
SWITCH OFF THE MOTION DETECTION SENSOR
The Motion detection sensor can be switched off by pressing the "Motion" button
L again. A sound signal
REMOTE CONTROL
This heater is e uipped
control are the same as the functions on the display of the heater.
J
CHILDPROOF LOCK / PARENTAL CONTROL
The childproof lock can be used to prevent children accidentally changing the
heater settings. When the heater is burning and the childproof lock is on, the heater
can only be switched off. Other functions are blocked then. If the heater has already
been switched off, the childproof lock also prevents accidental ignition of the
heater. Activate the childproof lock by pressing the appropriate key
it do n for more than 3 seconds. The KEY-LOCK indicator
information display ( ig. H), indicating that the childproof lock has been activated.
S itch off the childproof lock by pressing the key
than 3 seconds once again.
K
THE CORRECT USE OF 'SAVE'
The SAVE function allo s you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature exceeds
the set temperature by 3 C. Subse uently,
again to the set temperature, the heater ill automatically s itch on again. Activate the
SAVE setting by pressing the appropriate
display ( ig. I). S itch off the function by pressing the SAVE key once again.
Without the SAVE setting your heater
!
appro imation as
setting, which you can use when, for instance, you are not present in the room
or to keep it frost-free.
ith a motion detection sensor. The sensor is placed at
ill be heard and the "Motion" light
ith a remote control. The functions on the remote
hen the room temperature has dropped
ill maintain the set temperature by
ell, by adjusting its heating capacity. SAVE is an economy
hen the heater is
ill sound and the "Motion"
ill go out.
will appear on the
and holding it down for more
key. will display on the information
ill be used.
H: When the
appears, the childproof
lock has been activated.
and holding
I: When the SAVE func-
tion is activated, the
heater will automatically
switch on or off in order
to remain within a speci-
fied temperature range.
mark
4
11