Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MANUAL
A
INSTALLING THE HEATER
1
Carefully remove your heater from the box and check the contents.
In addition to the heater you also need to have:
¼ a manual fuel pump
¼ a transportation cap
¼ these directions for use
Keep the bo
transportation.
2 Open the lid of the removable tank ¿ and remove the piece of cardboard.
ill the removable tank as indicated in Section B.
3
4 The floor should be firm and completely level. Reposition the heater, when it
is not level. Do not try to correct the situation by placing books or other
goods under the heater.
5 Insert the plug µ into the
correct time using the adjustment keys
6 Your heater is now ready for use.
SET ALTITUDE
1 If the heater is used at a height of 800 m to 1300 m, use the altitude mode 1.
Push the altitude button
simultaneously. Then "1
2 If the heater is used at a height of 1300 m to 1900 m, use the altitude mode
2. After setting the altitude mode 1, push the altitude button
and plug into the outlet simultaneouosly again. Then "2
the display.
3 S itch off the altitude mode by pressing the altitude button
outlet simultaneously after setting altitude mode 2. Then "0" will be shown
on the display and "
NOTE: When the altitude mode 1 is set, the altitude mark "
When the altitude mode 2 is set, the altitude mark "
operation.
NOTE: In the event of power failure or disconnection of heater, the altitude setting
will remain.
!
Do not use the heater at a height of over 1900 meters.
SWITCH THE VOLUME
This heater can be s itched the bu er sound volume. The initial setting is in
High level.
1 Push the SAVE key
bu er sound volume is s itched from High to Lo .
2 Push the SAVE key
then the bu er sound volume is s itched from Lo
NOTE: The volume level is Lo
sounds in High level.
NOTE: When the heater has been unplugged or after a power failure, the volume
ill be the initial setting High.
and the packaging materials ( ig. A) for storage and/or
all-socket (230 Volts - AC / 50 H ) and set the
with thin rod like a clip and plug into the outlet
" will be shown on the display.
" will be disappeared.
and holding it do n for more than 3 seconds, then the
and holding it do n for more than 3 seconds again,
and High only, but the alarm by safety device
(refer to Section C).
with thin rod
" will be shown on
and into the
" is lit on the display.
" is blinking during
to High.
A
B
4
5
Publicité
Table des Matières
