Hood Maintenance - Summit Professional SEH1530C Manuel D'installation, D'utilisation Et D'entretien

15
Warning: Always switch off the electricity supply before carrying
out maintenance work on the hood. In the event of a fault, contact
an official distributor or authorized dealer.
Exterior cleaning: Use non-corrosive, liquid detergent and avoid the use
of abrasive cleaning products.
Grease filters: To avoid fires, clean thoroughly once a month or whenever
the display pilot light indicates the need. To do so, remove the filters and
wash with hot water and detergent. If using a dishwasher, position the filters
vertically to prevent solid remains from depositing on them.
Activated charcoal filters: Replace every 3 months.
Important: increase the filter cleaning/replacement frequency if the
hood is used for more than 2 hours a day. Always use genuine filters
from the manufacturer.
Bulb replacement (look for the
page 10)
Warning: Do not handle the bulbs until the electricity supply has been
switched off and they have cooled.
Important: Use new bulbs according to the type indicated on the hood
nameplate.
Use bulbs with an aluminum reflector to replace halogen bulbs. Do not use
dichroic bulbs – risk of overheating.
On kitchen hoods equipped with tungsten lamps, the lights should only be
used during operation of the motor. They should not be left on permanently
and used as a light source.

HOOD MAINTENANCE

symbol in the figures on