Installation Using A Transmitter; Installation Using The Command Buttons - Master LINE Manuel D'utilisation Et D'entretien

04. INSTALLATION USING A TRANSMITTER

A B (1)
ON
Connect the power Within 15s press PROG
supply of the transmitter
E
(2)
Press STOP 3 times
F G
(4)
The pergola moves
Wait automatic stop
downward
in lower limit switch
J
Pergola makes a briefly downward
movement and a briefly upward movement
(1) the motor is in "hold to run" mode: the motor moves in a certain direction until you release the button of the transmitter.
(2) the button must be pressed for 3 times briefly, about 1s between each press and the next. If button is pressed a number other than 3, the motor performs an error message.
(3) if you press Stop over time, the motor makes a short downward movement. In this case, repeat step E.
(4) now the motor moves in 'pulse' mode: to operate the motor press UP or DOWN of the transmitter; to stop the motor press STOP.
(5) during the process of fine tuning the motor makes small movements in the selected direction.
05. INSTALLATION USING COMMAND BUTTONS
A B (1)
ON
Bring the pergola in
Connect the power an intermediate
supply position
D E
(4)
The pergola moves Wait automatic stop
downward in lower limit switch
H I (5)
NO
Pergola makes a
signal
(1) the motor is in "hold to run" mode: the motor moves in a certain direction until you release a button
(2) the button must be pressed for 3 times briefly, about 1s between each press and the next. If button is pressed a number other than 3, the motor performs an error message.
(3) if you press button over time, the motor makes a short downward movement. In this case, repeat step C
(4) now the motor moves in 'pulse' mode: to operate the motor press the button for at least 0.5 seconds; to stop the motor press briefly (less than 0.5 seconds) any button
(5) you can memorize the transmitter even later (see Section 06 «Memorization - deletion of a radio device»)
C (2)
WARNING:
UP: the cloth retracts, the pergola
is discovered
DOWN: the cloth is stretched, the
pergola is covered
x3
H
The pergola moves
END OF
INSTALLATION!!!
C (2)
WARNING:
UP: the cloth retracts, the pergola
is discovered
DOWN: the cloth is stretched, the
pergola is covered
F
The pergola moves
Do you need
YES
to memorize
a transmitter?
Wait 15 12
9 3
seconds
6
Press UP briefly
The motor makes a short upward
movement
I
Stop manually
to set the desired
upper limit switch
upward
K
(5)
Press PROG
x3
Press briefly 3 times
button that move downward
the pergola
G
Stop manually
to set the desired upper limit switch
upward
Within 15 seconds press
STOP of the transmitter
2 briefly downward
movements
J
Press together
UP and DOWN
03
YES
Motor moves
upward?
NO
Press PROG
of the transmitter
(3)
Press STOP 1 time
J
Fine adjustment
required?
NO
Wait 10
seconds
FINE ADJUSTMENT
Make a fine
adjustmen
The motor makes a short
upward movement
the
J
Fine adjustment
required?
NO
Wait 10
seconds
1 briefly
upward
movement
FINE ADJUSTMENT
Make a fine
adjustmen
D
Bring the pergola in an
intermediate position
x1
YES
See
point K
12
9 3
6
Press PROG
(3)
x1
Press briefly a button
YES
See
point J
12
9 3
6
Press together
UP and DOWN