Parts & Features - Sephra CF18H Mode D'emploi

PARTS & FEATURES
(SEE ILLUSTRATIONS ON PAGES 4-7)
All models:
1. Crown—Rests on top of the stabilizer (4)
or cylinder (3a).
2. Top Tier—Slides into place after
positioning the bottom tier (6).
3. Full Cylinder (Signature model only)—
Stands on top of positioning pegs (7a) in
the center of the basin.
3a. Top Section of Cylinder (excluding
Signature model)—Attaches to the
bottom cylinder (3b).
3b. Bottom Section of Cylinder (excluding
Signature model)—Stands on top of the
pegs in the center of the basin (7a).
3c. Cylinder Sleeves—Slide over basin pegs
(7a) to hold cylinder in place.
4. Stabilizer (Signature model only)—Slides
over the top of the cylinder and holds the
top tier and crown in place.
5. Auger—Fits inside the cylinder and
carries fondue to the top of the cylinder,
creating a constant flow of the fondue from
the top of the crown into the basin.
6. Bottom Tier—Slides into position on the
cylinder (3 or 3b).
7. Stainless Steel Basin—Holds the fondue.
The Signature, Elite, and Classic models
hold 4–5 pounds of chocolate (7–9 cups).
The Select model holds 3–4 pounds of
chocolate (5–6 cups). This basin is
removable in the Signature and Elite
models.
7a. Basin Pegs—Hold cylinder in place.
8. Fountain Base—Housing that surrounds
electrical components including the motor
and the electrical circuit board.
8
8a Vent Holes (excluding Select model)—
Allow hot air produced by the motor and
heating element to escape, cooling the
electrical components. The vent holes
should not be covered.
9. Slip-Resistant Legs (excluding Select
model)—Reduce movement during use
and help prevent marks on tables and
countertops.
10. Adjustable Feet—Screwed into the bottom
of the base. Can be tightened or loosened
to raise or lower a particular side of the
fountain, adjusting its level.
11. "Whisper Quiet" Motor (not pictured)—
Inside fountain housing (8). Designed to
be as quiet and unobtrusive as possible.
Some motor and moving parts noise is to
be expected. The motor is equipped with
an automatic shut-off in the event that
the fountain overheats.
Signature and Elite models only:
12. Control Panel—Regulates all functions
of the fountain.
12a. ON/OFF/POWER button—A green LED
light will be lit when the power is ON.
12b. START button—Starts the motor, causing
the auger to spin inside the cylinder. A
green LED light will be lit when the START
button has been pressed and the auger is
spinning.
12c. HEAT button—Changes the temperature
settings. Each time the button is pressed,
the heat will cycle to the next temperature
setting, moving from OFF to HIGH. A red
LED light will be lit at each temperature
setting except the OFF position, where the
LED light is yellow. The red LED light will
blink intermittently as power is supplied
to the heating element.