Layout Settings; Ribbon Save - Continuous Mode - Valentin FLEXICODE Guide De Référence Rapide

Flexicode

Layout Settings

Keys: , , ,
Print length
Key:
Column printing
Key:
Material selection
Key:
Invert layout
Key:
Flip layout
Key:
Rotate layout
Key:
Alignment
Ribbon Save
Keys: , , ,
Continuous Mode
Mode
Key:
Transfer ribbon correction
120
Indication of the print length in mm.
Indication of way which the print mechanics has to move. The print length depends on the length
of the print mechanics.
Indication of width of one layout as well as how many layouts are placed side by side.
Selection of the used print materials.
On: Layout is printed inverse.
Off: Function is deactivated.
The axis of reflection is in the middle of the layout. If the layout width was not transferred to the
print module, automatically the default layout width i.e. the width of the printhead is used. It is
recommended to use layouts with the same width as the printhead. Otherwise this can cause
problems in positioning.
According to standard the layout is printed ahead with a rotation of 0°. If the function is
activated, the layout is rotated by 180° and printed in reading direction.
The adjustment of layout is effected only after 'flip/rotate layout', i.e. the adjustment is
independent of the functions flip and rotate.
Left: The layout is aligned at the left-most position of printhead.
Centre: The layout is aligned at central point of printhead.
Right: The layout is aligned at right-most position of printhead.
,
Selection of ribbon save mode.
Off: Ribbon save set to Off.
Standard: Maximum ribbon save performance, i.e. with this setting there is no loss of transfer
ribbon (apart from the safety distance of 1 mm, so the print fields are not printed one into the
other).
0 mm = It is always so far retracted that an optimal ribbon save is reached (no loss of transfer
ribbon).
Default: -1 mm
−xx mm = The feedback can be made smaller.
+xx mm = The feedback can be made larger.
English