Sygonix Lucca 23620S Notice D'emploi page 2

Operating instructions
GB
LED nightlight „Lucca",
with colour change
Intended use
The product is intended for operation in a wall socket (230V/AC, 50 Hz) and is oper-
ated as a nightlight. The alternating colours of the integrated LEDs ensure a particu-
larly decorative light effect.
The safety instructions must be observed at all times!
Any use other than that described above could lead to damage to this product and
involves the risk of short circuits, fi re, electric shock, etc. No part of the product may
be modifi ed or converted!
This product complies with the applicable national and European requirements. All
names of companies and products are the trademarks of the respective owners. All
rights reserved.
Package Contents
• Nightlight
• Operating instructions
Explanation of Symbols, Inscriptions
The lightning symbol indicates a health hazard, e.g. electric shock.
This symbol indicates specifi c risks associated with handling, function and
use.
The product is constructed according to Protection Class II.
The product is suitable only for installation and use in dry interiors; it
may not become moist or damp.
Observe the operating instructions!
Safety Instructions
The warranty will be void in the event of damage caused by failure to ob-
serve these safety instructions! We do not assume any liability for any
resulting damage!
We shall not accept liability for damage to property or personal injury
caused by incorrect handling or non-compliance with the safety instruc-
tions! The warranty will be void in such cases!
• Unauthorised conversion and/or modifi cation of the product is not allowed
for safety and approval reasons (CE).
• The product is not a toy and it should be kept out of the reach of children.
Children do not realize the danger arising from the incorrect use of electrical
devices. Therefore, be especially careful when children are around.
• Plug the product into a correct mains socket of the public mains supply only.
Do not connect the product to an extension cord.
• Do not use this product in rooms or under adverse environmental condi-
tions where combustible gases, vapours or dust are or where they may be
present! There is a risk of explosion!
• The product is intended for use only in dry indoor locations. It may not get
wet or damp; otherwise there may be danger of electric shock! Never touch
the product with wet hands!
• Do not expose the product to extreme temperatures, direct intense sun-
light, strong vibrations, high humidity or strong mechanical stress.
• Handle the product with care; it can be damaged by impacts, blows, or ac-
cidental falls, even from a low height.
• Never connect the product to the wall outlet immediately after the product
has been brought from a cold room into a warm one. Condensation that
forms might destroy the product. Furthermore, there is a danger of an elec-
tric shock. Wait until the product reaches room temperature and the con-
densation has evaporated. This may take several hours.
The home technology brand for the entire house. More information at www.sygonix.com
• If it can be assumed that safe operation is no longer possible, the device
must be turned off and precautions are to be taken to ensure that it is not
used unintentionally. After this, arrange for an expert to check the product.
Safe operation can no longer be assumed if:
- the product shows visible signs of damage
- The product does not work at all or works poorly (where there is fl icker-
ing light, leaking smoke or a smell of burning, audible crackling noises,
or discolouration to the product or to adjacent surfaces)
- the product was stored under unfavourable conditions
- it was exposed to heavy loads during transport
• Do not leave packaging material carelessly lying around, since it could be-
come a dangerous plaything for children.
• If you have any questions that are not answered in this manual, please con-
tact our technical service or another specialist.
Getting Started
• Plug the nightlight into a wall-mounted mains socket. The small, round brightness
sensor at the edge of the casing should point downwards.
• The brightness sensor integrated in the nightlight activates it automatically when
the brightness in the room falls below a certain level (e.g. at night). The nightlight
turns off automatically when it gets brighter.
The integrated coloured LEDs and the plastic lens result in a special light effect on
the wall.
• Press the button on the front side briefl y (press on the manufacturer logo), in order
to stop or resume the change of colour.
In order to do so, the nightlight must be switched on, e.g. at night. Alternatively, you
can cover the bottom side of the brightness sensor with an opaque adhesive tape,
so that the nightlight lights up.
Maintenance and Cleaning
• The product does not require any maintenance. You should never take it apart. The
LED bulbs used are installed permanently and cannot be replaced.
• Prior to each cleaning, remove the nightlight from the mains socket. When this has
been done, the nightlight can be cleaned with a soft, clean, dry cloth.
Dust can be easily removed with a soft, clean brush.
Do not use any aggressive cleaning agents. These can attack the plastic housing and
lead to discolouration.
Disposal
Dispose of an unserviceable product in accordance with the relevant
statutory regulations.
Technical Data
Operating voltage: 220 - 240 V/AC, 50 Hz
Power consumption: max. 0.5 W
Type of light source: 3 LEDs (not replaceable)
Protection class: II
Dimensions: 72 x 72 x 44.5 mm (W x H x D, without plug)
Legal notice
These operating instructions are a publication by Sygonix GmbH, Nordring 98a, 90409 Nürnberg (www.sygonix.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfi lming, or the capture
in electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is
prohibited. These operating instructions represent the technical status at the time of printing. Changes in techno-
logy and equipment reserved. © Copyright 2013 by Sygonix GmbH.
Nr. 23620S - Version 08/13