Rear Panel; Power Supply - Vonyx VDJ25 Manuel D'instructions

16. ECHO LEVEL CONTROL: Adjust the echo volume level.
17. BUTTON CLUSTER:
MODE BUTTON - Press to change modes between playing SD, USB, MP3 and BT.
REPEAT MODE - Press the repeat button once to continually repeat ALL tracks, press repeat once more to repeat just the
current track.
PREVIOUS - Press this button to go to the previous track. Press and hold to scan backwards within tracks.
PLAY / PAUSE - Press this button to start or pause play.
NEXT - Press this button to go to the next track. Press and hold to scan forwards within tracks.
18. ECHO DELAY: Adjust the delay time of the echo effect.
19. MICROPHONE INPUT: 6.3mm (¼") jack for connecting a microphone.
20. HEADPHONES SOCKET: 6.3mm (¼") output jack for connecting headphones. This allows for pre-listening (PFL signal).

REAR PANEL

1. ON/OFF SWITCH: Turns the unit ON/OFF.
2. SPEAKER OUTPUT: These terminals allow for connecting speakers.
3. MASTER OUTPUT: RCA connectors to connect the unit to an amplifier.
4. LINE 2 INPUT: This LINE input can be used to connect CD/MP3 players, etc.
5. PHONO INPUT: This input can be used to connect a record player.
6. LINE 1 INPUT: This LINE input can be used to connect CD/MP3 players, etc.
CONNECTING WITH BT
If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
4
1. Activate the BT-function on your device (Mobile phone, tablet etc.) from which you want to play the
music. See the operating instructions for that device.
Enter "BT" mode to activate BT-function.
2.
Select "VONYX" on your BT-device and make the BT-connection.
3.