Charger Mounting; Checking The Charger - GreenWorks 29717 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
2924107
3
2
RED
OFF
BLINKING
RED
GREEN
RED
BLINKING
RED
BLINKING
RED
LED 1
False Defect Note:
When the battery is inserted into the charger,
LED 1 flashes RED and LED 2 flashes
Green, remove the battery from the charger
for 1 minute, then reinsert. If the status LEDs
indicate normal, then the battery pack is
good. If the status LED 1 and LED 2 are still
blinking, remove the battery pack and unplug
the charger. Wait 1 minute and plug the
charger back in and reinsert the battery pack.
If the status LEDs indicate normal than the
battery pack is good. If the status LED 1 and
LED 2 are still blinking then the battery pack
is defective and needs to be replaced.

CHECKING THE CHARGER

If the battery pack does not charge properly:
▪ Check the current at the power outlet with
another tool. Make sure that the outlet is
not turned off.
▪ Check that the charger contacts have not
been shorted by debris or foreign material.
▪ If the surrounding air temperature is not
normal room temperature, move the
English (Original Instructions)
STAND BY
CHARGING
GREEN
FULLY CHARGED
OFF
HIGH TEMP.
BLINKING
ERROR
GREEN
LED 2
charger and battery pack to a location
where the temperature is between 7 ˚C and
40˚C .
1
If the battery is inserted into the charger
when warm or hot, the CHARGING LED
indicator light on the charger may switch
on and illuminate ORANGE. If this occurs
allow the battery to cool outside of the
charger for approximately 30 minutes.

CHARGER MOUNTING

1. This charger can be installed hanging on a
wall using two screws (not supplied)
2. Locate the placement for the charger to be
wall mounted.
3. If fastening to wood studs use 2 wood
screws.
4. For
Drill two holes 2 3/8" (6 cm) on
center
For charger 2924107: Drill two holes 5 3/4"
(14.5cm)on center ensuring they are level.
5. If fastening to drywall use wall anchors and
screws to secure the charger to the wall.
2910907/29417/29447
6
WARNING
charger
2910907/29417/29447:
ensuring
they
are
level.

Publicité

Table des Matières
loading

Table des Matières