Mounting The Ball Valve Onto Storage Tank; Connecting The Water Lines - PUR PUN3RO Manuel Du Propriétaire

Installation Instructions (continued):
Mounting the RO Unit Under the Sink:
1. Position the RO unit on the back or right walls under the sink. Make sure to allow ample space for the installation and
plumbing connections. To change the filter cartridges, 2" of clearance is required underneath the filter housings.
2. Install mounting screws at least 15-3/4" from cabinet floor. Leave 1/4" space between the head of the screw and the wall
to slip bracket onto the screws. Then tighten the screws to secure the system.
System Dimensions
PUN3RO
1-1/4"
11-1/2"
2" Clearance
Mounting the Ball Valve Onto Storage Tank (See Figure 12 and 13):
1. Connect the Ball Valve to the water Storage Tank thread on the upper side
of the Tank. Make sure the Black Rubber Gasket sits flat. Tighten the valve
but do not overtighten.
2. Connect the 1/4" Yellow Tubing to the Ball Valve. Push the Tubing in all
the way to make sure it is properly seated.
3. Turn the Ball Valve off.

Connecting the Water Lines:

CAUTION: Before cutting the supplied tubing, measure the distance
between the components.
All Tubing is color-coded for ease of installation.
1/4" Black:
Connects the waste water from the RO Membrane to the
Air Gap Faucet Intake Line.
1/4" Red: Connects the Inlet Valve of the cold water supply to the
inlet of the system.
1/4" Yellow: Connects the RO Membrane to the Storage Tank.
1/4" Blue:
Connects the outlet of the system to the Faucet.
3/8" Black:
Connects the Faucet to the Saddle Drain Clamp.
Note: Reference the diagram on page 3 or 4 for color and
connection points on the RO System.
9
15"
10-7/8"
15-1/2"
15"
7-3/8"
1-1/4"
11-1/2"
2" Clearance
Figure 12
Rubber
Gasket
Figure 13
Closed
PUN4RO
17-1/2"
Remove
Protective
Storage Tank
Open
Ball Valve
Storage Tank
Cap
1/4"
Yellow
Tubing