Installation - Klarstein BAROSSA 34 DUO Mode D'emploi

INSTALLATION

Before using your appliance
To ensure proper electrical connection, follow the recommendations given in the present
manual.
• Unpack the appliance and visually check that it is not damaged. Do not connect a
damaged appliance. Inform your retailer or point of sale of any damage. In such a
case, keep the packaging.
• It is recommended that the appliance be allowed to settle for at least 4 hours before
connecting the electrical power supply, so that the compressor fluid feed is correct.
• Proper air circulation is necessary to avoid overheating. To ensure sufficient
ventilation, observe the installation recommendations provided.
• In order to avoid fire risk, wherever possible, ensure that the appliance is not in
contact with walls or with any hot element (compressor, condenser). Observe the
installation recommendations.
• The appliance should not be placed close to radiators or cooking hot plates or gas
rings.
• Check that electrical sockets remain accessible when the appliance is installed.
• Before connecting the appliance to the electrical socket, leave it in position for 24
hours. This will reduce the possibility of malfunction of the refrigeration circuit due to
transport.
• Clean the inside using a soft cloth and lukewarm water.
Installing your appliance
• This appliance should be placed in a well ventilated, dry room.
• Position it in a place with sufficient strength to support its weight when loaded. To
ensure that it is level,adjust the height of the feet underneath.
• To get the best from your appliance with the lowest energy consumption, do not
place the appliance close to a heat source (heater, cooker, etc.), do not expose it
to direct sunlight, and do not place it in a room which is too cold.
• Plug the appliance into an exclusively, easily accessible plug socket. Any questions
power and /or grounding should be directed toward a certified electrician or an
authorized service centre.
• To prevent the appliance from heating up, ensure adequate ventilation and never
block or cover the air vents.
Note:Make sure that the socket and ON/OFF switch are easily accessible after the
appliance has been installed.
EN
29