Technical Data - Sulzer ABS CA 461 Guide D'installation

2

TECHNICAL DATA

2.1 Technical data CA 461
Leakage sensor voltage
Max sensor current
Leakage detection threshold
Alarm on delay
Ambient operating temperature
Ambient storage temperature
Degree of protection
Housing material
Mounting
Installation category
Pollution degree
Flame rate
Humidity
Dimensions
Power supply
Fuse
Terminal wire size
Terminal tightening torque
Power consumption
Max load output
Altitude
Compliance
Attention If the unit is used in a manner not described in this document the protection provided by the
equipment may be impaired.
2.2 Cleaning
How to clean the unit
Powers off the unit and only outside/front shall be cleaned by using a dry, soft cloth. A good choice
would be the microfiber type of cloth. Gently wipe the CA 461 unit front in order not to scratch the
overlay. If the dry cloth did not completely remove the dirt, do not press harder in an attempt to
scrub it off.
If necessary, moisten the cloth by adding a small amount of water with thin solution of mild deter-
gent and try again. Never use detergent with polish or solvent which can have an impact of the
plastic surface.
12 VDC
< 15 µA
< 100 kohm
10 seconds
–20 to +50 °C (–4 to +122 °F)
–30 to +80 °C (–22 to +176 °F)
IP 20, NEMA: Type 1
PPO and PC
DIN Rail 35 mm
CAT II
2
V0 (E45329)
0–95% RH non-condensing
H x W x D: 108 x 35 x 58 mm
(4.25 x 1.38 x 2.28 in.)
110-230 VAC, 50 Hz/60 Hz
16907010
16907011 18 - 36 VDC, SELV or Class 2
Max 10 A
Use copper (Cu) wire only. 0.2 - 2.5 mm
flexible core, stripped length 8 mm.
0.56 - 0.79 Nm (5 - 7 lbs-in)
< 2 W
250 VAC 3 Ampere
Max 2000 MASL or 6562 ft. AMSL
4
2
en