Conrad Renkforce 1377991 Mode D'emploi page 3

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating instructions
Mini dehumidifier
Item no. 1377991
Intended use
This product is designed to dehumidify small rooms (15 - 20 m²). The dehumidifier
works with a thermoelectric peltier module and is therefore very quiet compared with
compressor-operated dehumidifiers.
It is intended for indoor use only. Do not use it outdoors.
For safety and approval purposes (CE), you must not rebuild and/or modify this product.
If you use the product for purposes other than those described above, the product may
be damaged. In addition, improper use can cause hazards such as short circuiting,
fire, electric shock etc. Read the instructions carefully and keep them. Make this
product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements.
All company names and product names are trademarks of their respective owners.
All rights reserved.
Delivery content
• Dehumidifier
• Power adapter
• Operating instructions
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on
proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may
become dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong
jolts, high humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of
operation and protect it from any accidental use. Safe operation can no
longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a
low height can damage the product.
• The device must not be used near bath tubs, showers, swimming pools or
washbasins. The product must not get wet.
• Never pour any liquids over electrical devices or put objects filled with
liquid right next to the device. If liquid or an object enters the interior of the
device nevertheless, first power down the respective socket (e.g. switch
off circuit breaker) and then pull the mains plug from the mains socket.
Do not operate the product anymore afterwards, but take it to a specialist
workshop.
• Do not cover the device (e.g. with a curtain, blanket etc.) to prevent it from
overheating.
• Do not use the dehumidifier with a time switch, separate remote control
system or other similar devices that switch the dehumidifier on/off
automatically, as this creates a fire hazard if the dehumidifier is covered
or installed incorrectly.
• Never use the product immediately after it has been brought from a
cold room into a warm one. The condensation generated could destroy
the product. The plug-in power supply unit also involves danger to life
by electric shock! Allow the product to reach room temperature before
connecting it to the power supply and putting it to use. This may take
several hours.
• If the wall plug transformer is damaged, do not touch it; there is danger
to life from electric shock! First, switch off the mains voltage to the mains
socket to which the wall plug transformer is connected (switch off at the
corresponding circuit breaker or remove the safety fuse, then switch off
at the corresponding RCD protective switch, so that all poles of the mains
socket are disconnected). You can then unplug the wall plug transformer
from the mains socket. Dispose of the faulty wall plug transformer in an
environmentally friendly way; do not use it any more. Replace it with a wall
plug transformer of the same design.
• The mains outlet must be located near to the device and be easily
accessible.
• As power supply, only use the supplied mains adapter.
• Only connect the power adapter to a normal mains socket connected to
the public supply. Before plugging in the power adapter, check whether
the voltage stated on the power adapter complies with the voltage of your
electricity supplier.
• Never connect or disconnect power adapters if your hands are wet.
• Never unplug the power adapter from the mains socket by pulling on the
cable; always use the grips on the plug.
• When setting up the product, make sure that the cable is not pinched,
kinked or damaged by sharp edges.
• Always lay the cables so that nobody can trip over or become entangled
in them. This poses a risk of injury.
• For safety reasons, disconnect the power adapter from the mains socket
during storms.
• Always disconnect the power adapter before emptying the tank.
• Consult an expert when in doubt about operation, safety or connection of
the device.
• Maintenance, modifications and repairs are to be performed exclusively
by an expert or at a qualified shop.
• If you have questions which remain unanswered by these operating
instructions, contact our technical support service or other technical
personnel.
Operating elements
1 Dry air outlet grille (with filter net)
2 On/off switch (I / O)
3 LED indicator (ON)
4 LED indicator (FULL) (water tank is full)
5 Air inlet grille
6 Removable water tank
7 Connection socket for power adapter
(on product rear)
8 Non-slip rubber feet
(on product underside)
9 Power adapter
(not shown on above image)
Operation
• Place the dehumidifier on a stable, clean, dry and horizontal surface.
• Ensure that the dehumidifier is turned off. The on/off switch (I / O (2)) must be
in the O position.
• Connect the low voltage plug on the power adapter (9) to the power input (7) on the
back of the dehumidifier. Insert the mains plug into a suitable power socket. The LED
on the power adapter turns on.
• Turn on the dehumidifier by moving the on/off switch (I / O) to the l position. The
LED indicator (ON (3)) turns on and the dehumidifier starts to dehumidify the room.
• When the water tank is full, the dehumidifier turns off and the FULL LED
indicator (4) turns red. The dehumidifier turns itself off as soon as there is approx.
400 ml of water in the tank.
1
2
3
4
5
6
7
8

Publicité

Table des Matières
loading

Table des Matières