BOND MANUFACTURING BH7001-2 Guide D'utilisation page 3

SAFETY INFORMATION
• Should the fire go out while burning, turn the gas valve off. Follow the instructions and wait five
minutes before attempting to relight.
• Do not use this fire table if any part has been under water.
• Do not pour water into fire table.
• Immediately call a qualified service technician to inspect the appliance and to replace any part of
the control system and any gas control which has been under water.
• Do not light or use gas unit if lava rocks are wet.Ensure lava rocks are completely dry before
igniting as intense heat could cause the rocks to crack or pop.
• Do not attempt to disconnect the gas regulator or any gas fittings while your fire table is in
operation.
• Do not handle fire table until it is shut off and completely cooled.
• The propane gas tank must be disconnected when fire table is not in use.
• Do not store a spare or disconnected propane gas tank under or near this fire table, or in the vicinity
of any other appliance.
• If the fire table is stored indoors,detach and leave propane gas tank outdoors.
• Remove the battery when not using the fire table for an extended length of time.
• Clean the battery contacts and also those of the device prior to battery installation.
• Do not enlarge valve orifices or burner ports when cleaning the valve or burner.
• Do not use this fire table on vehicles or boats. Always operate the appliance on flat ground outdoors.
• Remove the PVC cover from the fire table before operating the appliance.
• Do not lay the PVC cover over the fire table until it is turned off and completely cooled down.
• After a period of storage and/or non-use, the propane fire table should be checked for gas leaksand
burner obstructions before use.
• The propane fire table should never be used by children. Children must be supervised when they are
anywhere near the appliance.
• Please keep gas tank a minimum of 5 feet away from fire table when lit.
• The maximum gas supply pressure is 250psi.
• Clothing or other flammable materials should not be hung from the appliance, or placed on or near
the appliance.
• Any guard or other protective device removed for servicing the appliance must be replaced prior to
operating the appliance.
• All installation and repair should be done by a qualified service person. This appliance should be
inspected annually. More frequent cleaning may be required as necessary. It is imperative that the
control compartment, burners and circulating air passageways of the appliance be kept clean.
• Inspect the burner before each use of this fire table. If there is evidence of damage, the burner must
be replaced prior to use of this fire table.
• Inspect the hose before each use of this fire table. If the hose shows signs of cracks, abrasion,cuts or
damage, do not use this fire table. Fix the hose as required before using appliance.
• Remove the hose out of pathways where it may be tripped over or subject to accidental damage.
• Children and adults should be alerted to the hazards of high surfact temperatures and should stay
away to avoid burns or clothing ignition.
• Young children should be carefully supervised when they are in the area of this appliance.
• The LP gas supply tank must be constructed and marked in accordance with the specifications for
LP gas tanks of the U.S. Department of Transportation (DOT) or the National Standard of Canada
CAN/CSA-B339, LP gas tanks, spheres and tubes for the Transportation of Dangerous Goods; and
commission.
• The LP gas tank must have a listed overfilling prevention device (OPD) and a QCCI or Type
I,(CGA810) LP gas tank connection.
Caution:
Only use the pressure regulator and hose assembly supplied with this firebowl. Replacement
pressure regulator and hose assemblies must be specified or supplied by BOND MANU-
FACTURING CO.
Inspect the hose before each use of the appliance. If the hose shows signs of cracks,a brasions,cut or
damage of any kind, do not operate the appliance. Fix or replace the hose as required before using the
3