Prior To Use; Checking For Gas Leaks - FSC CAMPINGAZ Guide D'utilisation Et Entretien

Belgium, Luxembourg, United Kingdom, Ireland,
Portugal, Spain, Italy, Croatia, Greece, Netherlands,
Czech Republic, Slovakia, Hungary, Slovenia, Norway,
Sweden, Denmark, Finland, Bulgaria, Turkey, Romania,
GB
Poland:
The barbecue is equipped with a circular connector. It should
be used with flexible hose UK that is suitable for use with
butane and propane gas. hose UK length should not exceed
1.20 meters and should be changed if it has been damaged, if it
is cracked, or when national regulations require doing so.
Do not pull or pierce the hose UK. Keep away from any parts
of the barbecue that get hot. Check that the flexible hose
stretches out normally, without twisting or pulling.
Switzerland, Germany, Austria:
The barbecue should be used with flexible tubing that is
suitable for use with butane and propane gas. Tubing length
should not exceed 1.50 meters and should be changed if it has
been damaged, if it is cracked, or when national regulations
require doing so.
Do not pull or pierce the tubing. Keep away from any parts of
the barbecue that get hot. Check that the flexible hose
stretches out normally, without twisting or pulling.
Flexible tubing connection: To connect the tubing to the
connector on the barbecue, tighten the nut on the tubing firmly
but without excess force using the two wrenches provided:
- no. 20 wrench to
tighten the connector ,
- no. 17 wrench to
tighten the nut on the
tubing
e) Lid
Handle the lid carefully, especially during operation. Do not lean
over the base
f) Checking for gas leaks
1) Work outside, away from all sources of ignition. Do not
smoke.
2) Make sure the control knobs are in the "off" ( ) position.
3) Push the end of the
hose completely onto
the regulator nozzle
and secure with a
suitable clip.
4) Fit the regulator onto
the gas cylinder
accordance with its
instructions.
5) Use a gas leak solution
to test for leaks. Important: never use a naked flame to
check for gas leaks.
6) Apply the solution to the connections cylinder/regulator/
hose/apparatus (the control knobs should remain closed: off
position). Open the gas cylinder valve.
7) Bubbles in the gas leak solution indicate that there are gas
leaks.
8) The leak can be stopped by tightening any hose connection
or replacing any faulty component. The barbecue must not
be used until the leak is stopped.
9) Close the valve on the gas cylinder. Check for leaks at least
once per year and each time the gas cylinder is replaced.
in
g) Prior to use
Never use the barbecue until the instructions have been read
carefully and understood. Also, make certain that:
- there are no leaks
- the venturi tubes are not blocked
Venturi tube
openings
- the hose does not touch any components which may get hot.
- that the ventilation openings in the gas receptacle housing are
not obstructed, if appropriate.
Check that the venturi tubes (VT) cover
the injectors (IJ).
h) Lighting the grill burner
Read steps 1 to 6 before beginning with step 1.
1) Never light the barbecue with the lid closed, only
with the lid open.
2) Make sure the control knobs are in the "off" ( ) position.
3) Open the gas cylinder valve.
4) Press one of the 2 control knobs and turn it to the full
flame ( ) position, then immediately press the igniter
button ( ) until you hear the click. Repeat 3 or 4 times if
necessary until the burner is lit.
5) If the burner fails to light, turn the control knob to the "off"
position ( ). Wait 5 minutes before repeating the
operation. If your device has an electronic lighting function,
hold the button down for a few seconds to obtain
successive sparks.
6) As soon as the burner is lit, the other burner automatically
lights when the second control knob is placed in the full
flame ( ) position without pushing the automatic igniter
button again.
Important:
If the burner fails to light after the 2
control knob to the "off" position ( ) and check that the
burner oulets and venturi tubes are not blocked.
Venturi tube
openings
i) Grill burner-manual lighting
If the automatic ignition should fail to operate, turn the control
knob to the "off" position ( ) and wait 5 minutes.
Remove the droppings tray located under the tank, vertical to
8
ij
VT
nd
attempt, turn the
Outlet holes