Publicité
Les langues disponibles
Les langues disponibles
1/2" HEX BOLT
FRONT
REAR
PICTURE ABOVE DOES NOT SHOW INNER MOUNTING BRACKET ON CROSS TUBE FOR CLARITY - SHOWN ON PAGE 9
1971-1993 Dodge Pick Up:
1. Insert a 1/2" bolt with a 1/4" bolt plate down through the 1" diameter hole at the end of the frame. Do this on both sides. Fasten the frame brackets as shown, to the
frame with 1/2" conical washers and nuts. Leave the bolts loose enough to center bracket on frame of truck.
NOTE;
On some special frames all holes will have to be drilled as followed.
Loosely attach parts as noted in step 2. Clamp hitch to frame so the first and last hole in bracket is able to be used as drill guides to the frame.
2. Install the center section between the brackets as shown. Bolt through the center section and the brackets with 3/8" bolts, and 3/8" flange nuts. Use the holes shown.
Leave the nuts finger tight at this time. Some spare tire carriers may need to be modified if the hitch hits the carrier. NOTE: Be sure to use four holes to bolt the
brackets to the center section.
3. Using the hole in the bracket as a guide, drill a 1/2" diameter holes through the frame. Use the farthest front hole. Do this on both sides.
4. Insert 1/2" bolts with 1/4" bolt plates down through the frame and the bracket. Install 1/2" conical washers and nuts on the bolts.
5. Tighten the nuts in the following order:
First torque the 3/8" nuts to 35 ft•lb.
Then torque the 1/2" nuts to 70 ft•lb.
3/8" BOLT
1/2" CONICAL WASHER
NOTE: SIDE BRACKETS WILL DEFLECT WHEN TIGHTENED
1/2" CARRIAGE BOLT
1/4" BOLT PLATE
1/2" CONICAL WASHER
1/2" NUT
1/2" NUT
TOOLS REQUIRED
3/4"
SOCKET
3/4"
WRENCH
9/16"
SOCKET
9/16"
WRENCH
TORQUE WRENCH
3/8" FLANGE NUT
6
Publicité
