IDK MULTIMEDIA BC-08E Mode D'emploi page 3

OPERATION INSTRUCTION
Thank you for purchasing the BC-08E universal remote
control. Before you can use your new remote, you will need
to program it to operate the specific A/V home entertainment
equipment you wish to control. Simply enter the proper device
codes for your equipment and it is ready to use.
BATTERY INSTALLATION/CHANGE
1. On the back of the BC-08E, open the battery compartment
cover.
2. Insert two (2) AAA new Alkaline batteries.
3. Match the (+) and (-) poles correctly aligned into the
battery compartment.
4. Close the battery compartment.
NOTE : Removing the batteries for more than 2 minutes
will require you to reprogram your remote.
SETTING UP BY DIRECT ENTRY
To program your BC-08E to operate your TV :
1. Turn on your TV.
2. Press & hold the SET key and press the TV
once. At this time, the red LED light will light on.
3. Release the SET key and TV
4. Enter the 3-Digit TV code from the code list for your brand
equipment.
* If you perform this procedure correctly, the red LED light
will go out. Otherwise, the red LED flashes 2 times.
5. Aim the BC-08E at your TV and press POWER
Your TV should turn off. If none of the keys or only some
of the keys operate your V, repeat Steps 2-4, trying each
code listed for your brand until you find the one that
operates your TV.
6. Your BC-08E is now programmed to operate your TV. Write
down your TV code on the label at the back of the
BC-08E for future reference.
7. To program other equipment, repeat the Steps 1-6 for
your VCR and or SAT.
NOTE : To leave the SETUP during the code entering,
just press any of the [DEVICE] keys once. Otherwise,
if no code is entered within 10 seconds, the red LED light
will go out automatically.
SETTING UP BY AUTO SEARCH
This auto search method checks all its preprogrammed codes
to find the code that will operate your equipment automatically.
This method may take a few minutes.
1. Turn on your TV and press the device mode as TV
2. Aim the BC-08E at your TV.
3. Press & hold the SET key and POWER
same time for 4 seconds until the red LED light blinks.
Then release the SET key and POWER
AUTO SEARCH is now performed.
4. If the TV turn off, this indicates that the BC-08E is now
set to your TV.
5. Press any key to exit and the red LED will go out
automatically. The BC-08E is now ready to operate your
TV.
6. To check the code, press POWER
Press CH+/-, VOL +/-, , and other applicable keys. If
no function, repeat Steps 1-5.
7. To program other equipment, repeats the Steps 1-6 for
your VCR and or SAT.
SETTING UP BY MANUAL SEARCH
This manual search method checks all its preprogrammed
codes to find the code that will operate your equipment. This
method may take a few minutes.
key ey
key. y.
key. .
.
key at the
key. y.
to ON position.
1