Before First Use; Using The Kettle - Sencor SWK 4-NAB1 Serie Mode D'emploi

SWK 40WH-NAB1 / SWK 41GR-NAB1 / SWK 42BL-NAB1 / SWK 43OR-NAB1 / SWK 44RD-NAB1
SWK 45VT-NAB1 / SWK 46YL-NAB1 / SWK 47GG-NAB1 / SWK 48RS-NAB1 / SWK 4XXX-NAB1

BeFoRe FIRst Use

1 . Remove all wrapping material from the kettle and its power base A4 . Discard any plastic bags to
eliminate the suffocation hazard to young children .
2 . Fill the kettle with cold water up to the maximum water level mark A5 (40fl .oz / 5 cups / 1 .2L) . Boil
the water and discard it . Repeat this process 2 to 3 times .
note:
To boil water in the kettle, follow the instructions in the chapter "Using the Kettle" .
3 . Now the kettle is ready to use .

UsInG tHe KettLe

1 . Set the power cord to the desired length . Push the power cord into the groove in the power base
A4 . Place the power base A4 on a clean, stable, even surface .
2 . Fill the kettle with the amount of cold water needed . The kettle must be filled with at least
17fl .oz / 2 cups / 0 .5L of fresh water and must not be filled above the maximum water level mark
A5 (40fl .oz / 5 cups / 1 .2L) on the steam tube inside the kettle . You may fill the kettle through
the spout A3 or through the opening after lifting the lid A2 . After filling the kettle with water,
close the lid A2 . Make sure the lid A2 is closed firmly .
Warning!
Do not fill the kettle while it is on the power base A4 .
If the kettle is overfilled, boiling water may splash and scalding may occur .
3 . Place the kettle on the power base A4 . Insert the plug into an electrical socket . Check that the lid
A2 is closed firmly .
4 . Start the kettle by moving power switch A6 to "ON" .
Attention:
Do not turn the kettle on if it is empty . Using the kettle incorrectly may shorten its service life .
If you accidentally turn the kettle on with insufficient water or no water, the thermostat will
interrupt the electrical circuit when a certain temperature is reached . The kettle can be used
again after several minutes, as soon as its stainless-steel bottom has cooled down .
5 . As soon as water boils, the kettle turns off automatically . Before taking the kettle off the power
base A4, make sure it has automatically turned itself off . If the kettle has not turned itself off
automatically, turn it off manually by moving the power switch A6 to "OFF" .
note:
The operation of the kettle can be stopped at any time by turning the power switch "OFF" .
6 . Pour the boiling water into a prepared container, cup or mug . Be sure to carry the kettle upright,
especially when it is filled to the maximum mark .
If you wish to open the lid A2 to refill the kettle, first empty the kettle completely, so that you are
not scalded by escaping steam .
7 . After you finish using the kettle, unplug it from the electrical socket . Empty the kettle and allow it
to cool down .
2016
Electric Kettle
EN-7
12/2016