Setting The Power; Restoring Factory Settings - Farho NOVA LITTLE Mode D'emploi

Masquer les pouces Voir aussi pour NOVA LITTLE:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Increase the temperature measured by the ambient tempera-
ture sensor by 2°C by pressing
In our example the measured temperature by the sensor goes
from 21°C to 23°C.
To validate, save the new value and exit the mode, press
To exit the Expert settings, press
The reset to zero of the sensor calibration
To put the value of the correction to "0", do the following :
1- When the temperature measured by the sensor appears,
press
or
for at least 3 seconds.
2- To save and move automatically to the next setting press
. To exit the Expert settings, press
Important:
These changes should be performed by a
qualified staff, it should be performed in production or on
site during the first installation

SETTING THE POWER

To have a controller adapted to the towel rails and estimate the
energy consumed, it is essantial to set the power of the device.
1- Pre set value: 500W. Select a value between 500W and
1500W by pressing
or
2- To save and move automatically to the next setting press
.
3- To save the Expert settings, press
times.
.
.
3 times.
3 sec.
3 times.
.
3
25

RESTORING FACTORY SETTINGS

If the PIN code protection is disabled, the user, installer and ex-
pert settings are re-initialized:
1- From the Power setting setting, press
on the display.
÷2
2-
appears. Press
or
= Factory settings reset
÷2
= Factory settings not reset
3- Press the key
for 5 seconds. The device returns to its in-
itial configuration and goes back automatically to the Auto
mode.
The following factory values will be effective:
Settings
Operating
Comfort setting temperature 19°C
Boost duration
Keypad lock
User settings
Backlighting
Eco mode temperature
lowering-level
Frost protection temperature 7°C
Minimum set of Comfort
setting temperature
Maximum set of Comfort
setting temperature
Maximal Boost duration
Maximum ambient
temperature for the automatic
stop of the Boost
Temperature unit
«
W
.
appears
to select
.
Factory settings
60 min.
Disabled
L3
-3,5°C
7°C
30°C
60 min.
35°C
°C
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Nova

Table des Matières