Topcom OUTDOOR SPORTSWATCH 2000 Manuel D'utilisateur page 10

TOPCOM Outdoor Sportswatch 2000
10 PACER MODE
The pacer will generate beeps at a pre-defined beeping
rate.The beeping rate can be set from 30 to 180 beats per
minute (BPM) in step of 5.
10.1 USING THE PACER
• In current time mode, press [M] until PACER is
displayed.
• Press the [S/S] button to start the pacer.
• The step counter "St" will run in the middle of the
display (max 99999 steps)
• Press the [S/S] button to stop the pacer.
• To reset the step counter, press and hold the [L/R]
button when the pacer was stopped.
10.2 HOW TO SET THE BEEPING RATE
• Press and hold the [M] button for 2 seconds in Pacer Mode.
• When the beeping rate digits start to flash, press the [S/S] or [L/R]
button to increase / decrease the number. (Hold down the button to
change the number at a higher speed).
• When the setting is completed, press and hold the [M] button to exit
the setting display.
11 DUAL TIME MODE
The Watch includes a function to show the time for a second time zone.
The second digit of the dual time synchronizes with the Current Time.
• In current time mode, press [M] until T2 is displayed.
• Hold the [M] button for 2 seconds. The flashing "SET"
icon will be displayed.
• Press the [M] button to switch between hour and
minutes.
• When the digits are flashing (selected), press the
[S/S] or [L/R] button to increase / decrease the
number (Hold down the button change the number at a higher speed).
• When the setting is completed, hold the [M] button to exit the setting
display.
10
[S/S]
beep-beep