Mag One BPR 40d Guide D'utilisation page 25

Chapter 11
Initiating Radio Enable
Prerequisites:In One Touch Access, set the <required call type> to Radio ENABLE.
Procedure:
1 Select the channel with the subscriber ID that you want to enable transmission from.
2 Press the programmed One Touch Access button.
When your radio transmits enable signal, the red LED illuminates.
NOTICE: Your radio may transmit enable signal up to three times.
If initiating radio enable is successful, your radio shows the following indications:
• A positive indicator tone sounds.
• The green LED blinks once.
If initiating radio enable is unsuccessful, a negative indicator tone sounds.
The receiving radio restarts.
MN007942A01-AA
Initiating Radio Enable
25