Comfort Glow ELCG251 Guide Du Propriétaire Et Instructions D'installation page 6

OPERATING YOUR HEATER
1. First turn on the Power switch on the right side of the heater. You will hear a beep indicating power is
supplied to unit. The Power switch supplies power to all the function of the appliance. This switch must be in
" I" position for any functions including the remote control to work.
2. Setting timer to power-off
Caution! ONLY when heater mode is on can you set timer-power-off function.
3 .Setting timer to power-on
Caution! ONLY when heater mode is off can you set timer-power-on function.
4. Setting heat
When heater is off, press Heater button to start heater.
Press the Power button on the remote control, the heat and flame effect will be on.
Press the Power button again, heat and flame effect will be off. Heat and heater
indicator will be off. The fan will continue running for 30 seconds to disperse remaining
heat from inside.
Press the Timer button to set timer-power-off function (through control panel or remote
control).
The timer light will illuminate the time chosen. Press the Timer button to increase
duration from 1h-2h-4h-8h-0.
Press the Timer button to set timer-power-on function (through control panel or remote
control).
The timer light will illuminate the time chosen. Press the Timer button to increase
duration from 1h-2h-4h-8h-0.
Press the Heater button on the control panel or remote control, the heater will start
(The heater indicator is under the artificial charcoal set. When heat is on, the charcoal
set will light up and flicker automatically at a slow pace). Press the Heater button again
to turn heat off. Heat and heater indicator will be off; however the fan will continue
running for 30 seconds to disperse remaining heat from inside.
When the flame is on, the heater indicator will stay lit if you turn off the heat.
~ 6 ~