Assembly; Unpacking; Install The Wheel Kit; Connect The Battery - Black Diamond BD100619 Manuel De L'opérateur

ASSEMBLY

Your generator requires some assembly. This unit ships from our
factory without oil. It must be properly serviced with fuel and oil
before operation.
If you have any questions regarding the assembly of your
generator, call our Technical Support Team at 1-888-373-8272.
Please have your serial number and model number available.

Unpacking

1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the generator.
3. Carefully cut each corner of the box from top to bottom. Fold
each side flat on the ground to provide a surface area to work
with the generator.

install the Wheel Kit


The wheel kit is not intended for over-the-road use.
Install the Wheels
1. Before adding fuel and oil, tip the generator onto it's recoil
end.
2. Slide the roll pin (B) through the wheel (A) from the outside.
3. Slide the roll pin through the mounting bracket on the frame.
4. Secure with the r-clip (C).
5. Repeat to attach the second wheel.
c
A
cAUTiON
B
Install the Support Leg
1. Attach the support leg (D) to the generator frame with flange
bolts (E) and flange lock nuts (F).
2. Slowly tip the generator back down so that it rests on the
wheels and support Leg.

connect the Battery

1. Cut cable tie on each side of battery connector.
2. Push two halves of battery connector together tightly.

Add Engine Oil

DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the generator as a result of failing to follow these
instructions will void your warranty.
The generator rotor has a sealed, pre-lubricated ball bearing
that requires no additional lubrication for the life of the bearing.
16
f
D
WARNiNG

NOTicE

E