Cleaning And Maintenance Of The Washing Machine; Identify Usual Trouble Of Washer - RCA RPW250 Manuel D'instructions

Cleaning and Maintenance of the washing machine

End of program
The washing machine will send off the sound
of dou-dou at the end of any program operation " "
to remind you to take out the laundry or operate
it again.
After the sound ,the washing machine returns
to its power-off state with no display and all lights off.
Please shut off the tap, pull out the plug when not
in use to avoid water leakage or the fire accidents.
Clean the water inlet
After long time use the water inlet mesh bag may
be blocked with smudginess and should be cleaned
according to the following steps
1 Switch on the power followed by shutting off the tap
2 Let the washer works for 5 seconds so that water
flows into the tub through the water inlet hose then
turn off the power
3 Unload the water inlet hose and clean the mesh bag
then restore the water inlet assembly
Notes:
If the drain filter is not cleaned at proper time (every 10 times of use),Drain problem could be caused.
Maintenance
Use gentle clothing to wipe off the water and dirt on
the surface each time after using the washing machine.
Detergent , propellant and
other chemicals are not
allowed to use so as to avoid
any damage to the plastic
accessories.
Clean Of the filter
After using the washing machine for a period please clean
it according to the following steps
1 Take out the lint filter
2 Open the filter and wash it clean in the water
3 Restore it and fix it
(only for magic filter)
After using the washing machine for a period, clean it
according to the following steps:
1. Take off the lint filter.
2. Turn over the mesh bag and wash it clean in the water.
3. Restore and fix it.
(only for normal filter)
16

Identify usual trouble of washer

When the washer is in trouble, please contact local service office or the sales service
department of our company and the customer should not dismantle the machine without
permission.
If the washer can not work normally, or appear abnormity or alarms, please check and
correct as follows.
List of faults and inspection
Faults
! If the power is off or the fuse is burned out.
! If the water supply is cut off or the water pressure is too low.
! If the inlet hose is properly connected and the water tap is opened.
! If the filtering screen of inlet valve is blocked by dirt.
No water
! If the coil of inlet valve is damaged. (The slight electromagnetic
flows in
sound is normal phenomenon when the inlet valve is switched on)
! If the "Start / Pause" button is pressed after the power
switch is pressed.
! If the power is off or the fuse is burned out.
! If the power supply voltage is too low.
! If the water amount reaches to the required water level.
No
(The washer will not work if the water amount does not reach the
washing
required water level)
! If it is set to "Delay" washing mode. (It will only start to work
until the reservation time reached)
! If the water drain hose is placed very high.
Abnormal
! If the end of water drain hose is sealed in pond.
draining
! If the internal rubber ring of drain valve is blocked by dirt.
! If the door lid is closed.
! If all clothing piled largely at one side of barrel or the clothing
Abnormal is excessively placed.
spin ! If the washer is not placed in stable condition or it is placed in
inclination state. (The ground is not flat).
! If the motor belt is loosened.
Note: During the spin process, if washing are piled at one side of the spin barrel, it
will cause unbalance of spin barrel resulting in striking. At this moment, the
computer inside the washer will feel this unbalance phenomenon and will automatically
correct it ( fill in water Washing ). However, if unbalance situation is not removed after
continuous three corrections, which means the computer auto-correction can not
resolve the problem. Then the user has to manually and evenly place the clothing
inside the barrel to solve the problem.
Inspection Items
17