Bimar VR28 Notice D'instructions page 15

 The plug point must be accessible so as to easily remove the plug in case of an
emergency.
 Stand the appliance on a flat, horizontal and stable surface, and keep it away
from:
- heat sources (e.g. open flames, gas stoves, etc.)
- liquids (e.g. from bathtubs, showers, sinks etc.) to avoid splashing water and to
prevent it from falling into them (the appliance should be kept a minimum of 2
metres away).
- fabrics (curtains, etc.) or floating materials/particles that may block the
aspiration grid; check also that the front part is free from floating particles
(dust, etc.).
 Be very careful when moving the tank when it contains water, and act by
gripping only the side handles; only move the appliance in a vertical position,
never bend it.
 If there is a fault or the appliance is not working correctly, switch it off and have
it checked by a qualified professional. Repairs done by an unqualified person can
be dangerous and cause the guarantee to become void.
 The appliance has the following controls (refer to the image):
Side handles (5) for easy transport.
-
Water tank (8), at the bottom. Remove the lid (9) towards the outside using
-
the handle (10), insert demineralized water (without limescale), and free of
additives (essences, detergents, or other), without exceeding the max. level
(about 8L: running time of about 8/12 hours) through water inlet (14). If the
water inside the tank is finished, switch off the cooling function using the
button (11). To remove and empty the tank, it is advisable to place the main
unit on a support surface and then unscrew the 4 fixing screws (4) and
remove the transparent plastic lid (7).
Front grille: the upper (3a) and lower (3b) horizontal flaps can be adjusted up
-
or down manually and separately. The vertical flaps (4), automatically swivel
15/48