Philips SalonDry Control HP4984 Mode D'emploi page 7

danger
- Keep the appliance away from water. Do not use it near or over
water contained in baths, washbasins, sinks etc. When you use the
appliance in a bathroom, unplug it after use. The proximity of water
presents a risk, even when the appliance is switched off.
- Do not insert metal objects into the air grilles to avoid electric shock.
- Never use any accessories or parts from other manufacturers or that
are not specifically advised by Philips. If you use such accessories or
parts, your guarantee becomes invalid.
Warning
- Check if the voltage indicated on the appliance corresponds to the
local mains voltage before you connect the appliance.
- Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the cord or the appliance itself is damaged.
- If the mains cord is damaged, you must have it replaced by Philips, a
service centre authorised by Philips or similarly qualified persons in
order to avoid a hazard.
- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
- Children should be supervised to ensure that they do not play with
the appliance.
Caution
- For additional protection, we advise you to install a residual current
device (RCD) in the electrical circuit that supplies the bathroom. This
RCD must have a rated residual operating current not higher than
30mA. Ask your installer for advice.
- Never block the air grilles.
- If the appliance overheats, it switches off automatically. Unplug the
appliance and let it cool down for a few minutes. Before you switch
the appliance back on, check the grilles to make sure they are not
blocked by fluff, hair, etc.
EnglisH