General Information; Changing The Fuse - 3B SCIENTIFIC PHYSICS U33010 Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 5
2. Description
The 5 kV high voltage power supply is a universally
usable non-earthed high voltage source for operat-
ing electron tubes.
It provides a continuously variable stabilized high
voltage with passive current limitation, in a hous-
ing that is safe to handle. It also incorporates a
transformer, insulated against high voltage, to
supply the cathode heater voltage for an electron
tube. A temperature-controlled fan protects the
equipment from overheating.
The U33010-115 high voltage power supply is for
operation with a mains voltage of 115 V (±10%),
and the U33010-230 unit is for operation with a
mains voltage of 230 V (±10%).
3. Technical data
Mains voltage:
High voltage output:
Heater voltage output:
Overload protection:
Terminals:
High-voltage display:
Dimensions:
Weight:
3B Scientific GmbH • Rudorffweg 8 • 21031 Hamburg • Germany •
see rear of housing
0 - 5000 V DC, max. 2 mA
6.3 V AC, max. 3 A, high
voltage resistant up to 6
kV
Primary fuse: see rear of
housing
Secondary protection:
current-limiting resistors
4 mm safety sockets
analogue
3
235x130x155 mm
ap-
prox.
3.5 kg approx.
Subject to technical amendments
© Copyright 2008 3B Scientific GmbH
4. Operation

4.1 General information

Before switching on the power supply, set the
high voltage regulator to zero (turn fully to the
left).
Connect the power supply to the experimental
setup.
Do not switch the power supply on until the
experiment has been fully assembled.
Changes to the experimental setup must only
be made with the power supply switched off.
Set the high voltage regulator to give the re-
quired voltage.
Before switching off the power supply, set the
high voltage regulator to zero again (turn fully
to the left).

4.2 Changing the fuse

Turn off the power switch and unplug the
mains plug.
Unscrew the fuse holder on the rear side of the
housing with a screwdriver.
Replace the fuse and reinsert the holder in its
socket.
www.3bscientific.com

Publicité

Table des Matières
loading

Table des Matières