Important - Ener-G+ HEA-23046WMRM Guide D'utilisation

3. OPERATION
Once your certified electrician has installed the proper connector (30 Amp, 240V) to the heater, connect the
power cable to a 30 Amp wall outlet that is designed and certified for outdoor use.
MAKE SURE THE HEATER IS NOT FUNCTIONING BEFORE YOU HANG IT ON A GAZEBO, OR UNDERNEATH A BALCONY
OR A ROOF.
NOTE: Wait until the heater's heating element has cooled down before moving it.
REMEMBER: Portable electric heaters are designed for spot heating or as a supplementary heat source. They are not
intended to be the main source of heat during cold months.
Caution:
You must always make sure that there is at least 1' 6" (50 cm) of empty space above the heater, 1'
from the side and 5' (1.8 m) below the heater.
Control Panel
Remote control
Press the On/Off switch to activate the heater.
Press the remote control once to operate the heater on 1500W power.
Press the remote control twice to operate the heater on 3000W power.
Press the remote control three times to shut off the heat.
IMPORTANT: To operate properly, the remote must be pointed toward the remote control sensor.
1
6" (50 cm)