Ener-G+ HEA-23046WMRM Guide D'utilisation page 3

Wall mounted: Brick or Concrete
Step 1: Using the wall mount bracket as a template
mark the four holes where you plan to install the
radiator. Drill four holes into the wall and hammer the
supplied four M6*50 expansion bolts into the wall.
Step 2:
Unscrew the four nuts, spring locks washers and plain
washers from the four expansion bolts. Keep them for
the next step.
Wall mounted (Other surfaces):
Step 1: Using the wall mount bracket as a template mark the four screw holes where you plan to install the radiator.
Step 2: Place the radiator with the mounting bracket on the four marks and tighten four screws (not included).
Step 3
Once installed, you can adjust the heater to the desired angle.
Step 3:
Fix the mounting bracket over the four expansion bolts.
Step 4
Once installed, you can adjust the heater to the desired
angle.