Technical Data - DRESTER WM-90 Manuel D'utilisation

Only applicable for the Drester WM-90-1 and WM-90-2
The machine can be used with all types of paints, solvent based as well as water based.
Collecting drums: (Only applicable for Drester WM-90-1 and Drester WM-90-2)
Place an empty collecting drum under each funnel. Place the drain hose into the drum and cut hose to an appropriate length if
necessary.
Waste bags: (Only applicable for Drester WM-90-2 and Drester WM-90-3)
Fit a waste bag to the stand. Place stand under the black waste collector inside the unit.
Drester WM-90-1 and Drester WM-90-2
Open lid and place can or bucket in the funnel. Close lid and leave can to drain completely.
Drester WM-90-2 and Drester WM-90-3
Open lid and place waste in waste bag. For easy removal of waste bag, replace bag before it is completely full.
In order to maintain the high safety standard of the unit, you should ensure the following:
- that the unit is installed in the manner prescribed in this manual
- that the unit is used in the manner prescribed in this manual
- that the unit is maintained in the manner prescribed in this manual
- that only original spare parts are used
- that this manual is kept available and in legible condition close to the unit.
Always wear protective solvent-resistant gloves when handling cans or other items wet with solvent.
Personnel suffering from chronic respiratory problems or allergies to solvents used must not operate the machine.
Two fire extinguishers must always be kept nearby when working with flammable solvents.
If plastic drums are used, the openings should be wiped with a damp cloth to avoid static electricity
When changing drums (Only applicable for Drester WM-90-1 and WM-90-2):
- Check and if necessary clean the funnel and the working platform, alternatively replace the funnel and working platform
(Drester no. 13490 and 13401)
- Check the drain hose for paint build up and if necessary replace the hose with new one (Drester No. 13370)
Hedson Technologies AB will replace all faulty parts on the DRESTER WM-90 with new parts in accordance with the
"Warranty Terms for Hedson Technologies AB". This warranty only remains valid if the machine is used in the prescribed
manner, and it does not cover the cost of repairs. Always state the machine's serial number and year of manufacture if making
a claim under warranty. These can be found on the machine's silver-coloured rating plate. The warranty terms may vary from
country to country. The importer can provide you with details.
Manufacturer:
Type of machine:
Permitted solvents:
Compressed air needed for ventilation: 7–12 bar (80-180 psi), 450 l/min (16 cfm)
Weight:
Overall dimensions:
Extractor diameter (option):
PERMITTED SOLVENTS
PREPARATIONS FOR USE
OPERATING INSTRUCTIONS
SAFETY INFORMATION
SERVICE
WARRANTY

TECHNICAL DATA

HEDSON TECHNOLOGIES AB
Hammarvägen 4
SE-232 37 Arlöv
Sweden
( +46-40-53 42 00
DRESTER WM-90
See section "Permitted Solvents"
42 kg
Height standard: 1025 (40") Height with hood: 1470 mm (58") Width: 780 mm (31")
Depth: 570 mm (23") (at the floor)
125 mm (5")
3