Velleman VM101 Mode D'emploi page 10

Learning Mode & Factory settings
DELAY 1 :
LD4 flashes
Press mode button (LD3 will light)
At release, DELAY1 starts registering (LD2&LD3 flash alternately)
Wait until desired time has elapsed.
Briefly press mode button to stop recording (LD2 will flash)
To confirm DELAY1 press mode button again (LD1 lights)
DELAY 2 :
Press mode button (LD3 will light)
At release, DELAY2 starts registering (LD2&LD3 flash alternately)
Wait until the desired time has elapsed.
Briefly press mode button to stop recording (LD2 will flash)
To confirm DELAY2 press mode button again (LD1 lights)
Both delays are now stored in memory.
FUNCTION 15 : Restore factory settings ( )
LD1 & LD4 will flash alternately.
Push mode button to restore factory settings.
LD1 will light for 3 seconds while the default settings (DELAY1 = 3 min; DELAY2 = 1 min; FUNCTION 1) are restored.
If you have selected this setting by accident, you can override the writing to memory by pressing the push button connected
to the control connector.
10