Accessories And Spare Parts - Windsor Recover 17 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Cleaning the electrodes
Release and remove the vacuum head.
Clean the electrodes.
Insert and lock the vacuum head.
Troubleshooting
Vacuum motor does not run
Check cables, plugs, fuse, socket and
electrodes.
Turn on the machine.
Suction turbine turns off
Empty the container.
Suction turbine does not start again
after the container has been emp-
Turn off the appliance and wait for 5
seconds, turn it on again after 5 sec-
onds.
Clean the electrodes as well as the
space between the electrodes.
Vacuum capacity decreases
Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
Exchange the paper filter bag.
Ensure the filter cover properly locks
into place.
Clean or replace the membrane filter
(special accessory).
Replace the flat pleated filter.
Check drain pipe for leaks.
8
English
tied
Dust comes out while vacuuming
Check for proper installation of the flat
pleated filter.
Replace the flat pleated filter.
Automatic shut-off (wet vacuum
cleaning) does not react
Clean the electrodes as well as the
space between the electrodes.
Continuously check the filling level in
case of non-conductive liquid.

Accessories and Spare Parts

– Only use accessories and spare parts
which have been approved by the man-
ufacturer. The exclusive use of original
accessories and original spare parts
ensures that the appliance can be oper-
ated safely and troublefree.
– At the end of the operating instructions
you will find a selected list of spare parts
that are often required.

Publicité

Chapitres

Table des Matières
loading

Table des Matières