KSIX TRUEBUDS 2 Guide De L'utilisateur page 2

Connect the True Buds earpieces to each other
1. Take the earphones out of the case to turn them on.
2. Once they are on, the LED indicators will blink blue and red.
3. After a few seconds, both LEDs will blink blue slowly. This means that the earpieces have
linked to each other.
Connect both True Buds earpieces to your mobile device
1. Once the earpieces have linked to each other, turn on Bluetooth on your mobile device.
2. Find and select the signal named "TRUEBUDS" to link the earphones to your mobile
device.
When turning the earphones on, they will reconnect to the last linked mobile device, as
long as Bluetooth is activated on the device.
Note: If it is not possible to connect the earpieces to each other by following the steps
given, restart them.
How to restart (factory reset) True Buds earphones
1. Turn o Bluetooth on your mobile device and turn o both earpieces.
2. Turn on both earpieces at the same time.
3. Wait for a few seconds until the earpieces connect to each other. Once they have linked,
both LED indicators will blink red & white, slowly.
4. Turn on Bluetooth on your mobile device and connect it to the earphones.
How to charge the battery of the True Buds earphones
When the battery of the True Buds earphones is low or depleted, charge them using the
case.
1. Place the earphones in the case.
2. Connect the case to a power source using the TYPE-C-USB cable. You can connect it to a
USB port on a computer or a laptop.
Note: Connecting the charging case to a power outlet requires an adaptor that is not
included with this product.
3. While the earphones are charging, the LED indicators will turn on red.
4. When the earphones are through charging, the LED indicators will turn o .
The case can also be used to charge the earphones independently, without needing to be
connected to a power source.
How to charge the earphones only using the charging case
1. First, you should charge the case's internal battery. To do this, connect the case to a
power source using the Type C USB-USB cable.
2. While the case is charging the LED indicator will blink white. When the case's internal
battery is fully charged, the LED indicator will remain white, without blinking.
3. Once the case's internal battery is fully charged, place the earphones inside the case to
charge them.
Maintenance recommendations
• Regularly clean the product with a dry cloth. The product must be disconnected or
switched o when you clean it.
• Keep the connectors and/ or ports free from dust, lint, etc. to prevent improper
connections.
• Avoid breaking the device. Do not put objects over it or bend it too strong.
• If the product includes a cable do not bend it too strong and do not pull from it to unplug
the product.
• Do not wet the product. Keep it always in a dry place, away from humidity.
• When not using the product, store it in a place free from dust, dirt, lint, liquids, etc.
z• If water or other liquids enter the product interior, unplug it immediately from any
attached power source or device it is connected to.
• Avoid dropping or hitting the product. It might be damaged.
• Do not use the product for anything other than its intended use.
• Please recycle the product in accordance with local environmental laws and regulations.
Safety information
Please read the following instructions before using the device for the first time:
• When you use device keep it away from heat sources (fire) and from humidity sources
(water and other liquids).
• If the product is wet or damaged do not us it.
• Do not use the product with wet hands.
• Do not leave the product in contact with flammable materials.
• Do not expose the product to high temperatures (for example: inside a car during hot
weather)
• Do not throw the product into fire.
• Keep the product away from children.
• Disconnect or switch o the product if you are not going to use for a long period of time.
• Do not use the device if you perceive any visible defects.