Dostmann 30.3009.54.IT Livret D'instructions page 22

HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE STATION
The temperature station uses 2 x AA, IEC LR6, 1.5V batteries. To install and
replace the batteries, please follow the steps below:
1.
2.
3.
Note:
In the event of changing batteries in any of the units, all units need to be reset by
following the setting up procedures. This is because a random security code is
assigned by the transmitter at start-up and this code must be received and stored by
the temperature station in the first three minutes of power being supplied to it.
SETTING UP:
WHEN ONE TRANSMITTER IS USED
First, insert the batteries in the transmitter (see "How to install and replace batteries in the
1.
temperature transmitter" above).
2. Within 2 minutes of powering up the transmitter, insert the batteries in the temperature station
(see "How to install and replace batteries in the temperature station" above). Once the
batteries are in place, all segments of the LCD will light up briefly. Following the indoor
temperature and the time as 0:00 will be displayed. If this information is not displayed on the
LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before
reinserting them. Once the indoor data is displayed the user may proceed to the next step.
Insert finger or other solid object in the space at the bottom center of the
battery compartment and lift up to remove the cover.
Insert batteries observing the correct polarity (see marking).
Replace compartment cover.
21