Maintenance Instructions; Lubrication; Cables; Clutch Jaws Replacement - RIDGID K-75A/B Mode D'emploi

K-75A/B, K-1500A/B, & K-1500SP Drain Cleaning Machines

Maintenance Instructions

Make sure machine is unplugged from power
source before performing maintenance or making
any adjustment.
Moving Parts Lubrication
Grease all exposed moving parts such as rocker arms
and main bearing approximately every three months.
Make sure to grease main bearing thru grease fitting in-
side clutch handle slot.
Clutch Jaws Lubrication
Clean and lubricate clutch driver jaws with oil after each
use.

Cables

Cables should be thoroughly flushed with water to pre-
vent damaging effects of sediment and drain cleaning
compounds. Periodically lubricate cables and couplings
with RIDGID Cable Rust Inhibitor.
When not in use, store cables indoors to prevent dete-
rioration by the elements.
Cables should be replaced when they become severely
corroded or worn. A worn cable can be identified when
outside coils of cable become flat.

Clutch Jaws Replacement

1. Remove four screws holding the front guard to the
housing.
2. Remove screws from the nose piece assembly
(Figure 12).
Figure 12 – Replacing Clutch Jaws
Find Quality Products Online at:
WARNING
GlobalTestSupply
Ridge Tool Company
www.
3. Slide out clutch driver jaws and replace with desired
size jaws.
Figure 13 – Replacing Clutch Jaws
4. Replace nose piece assembly, screws and guard.
WARNING Never operate machine with belt guard
removed. Fingers can be caught between the belt and
pulley.

Removing Clutch End Play

1. To remove end play from clutch, loosen screw in
Adjusting Nut. (Figure 14).
2. Turn lock and adjusting nut clockwise until snug
against housing, then back off one half turn.
3. Tighten screw in lock and adjusting nut.
Figure 14 – Removing Clutch End Play
.com
sales@GlobalTestSupply.com
11