Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 BHc 5x40 screws
- 4 M5 nylock nuts
- 4 Ø5 plastic washers
- 4 Ø5 wide plastic washers
Assembly
- Remove the rear saddle, disconnect the indicators and remove the original number plate
support.
- Connect the indicators, place the provided plate holder and fit it thanks to the furnished screws
(wide washers are placed inside the motorbike).
- Fit the number plate on its support.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we
made with original tyres and whose dimensions correspond to these ones engraved on tyre.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
FITTING INSTRUCTIONS
« PLATE HOLDER »
« CAUTION »
R6 2003/2005
Publicité
