JVC KD-R690S Manuel D'instructions page 23

INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate (B) Trim plate
(C) Mounting sleeve (D) Wiring harness
(E) Extraction key
Basic procedure
1 Remove the key from the ignition switch, then disconnect
the terminal of the car battery.
2 Connect the wires properly.
See Wiring connection. ( 24)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the
terminal of the car battery.
5 Detach the faceplate and reset the unit. ( 3)
Installing the unit (in-dash mounting)
Orientate the trim
plate as illustrated
before fitting.
When installing without the mounting sleeve
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with screws
(commercially available).
Use only the specified screws. Using wrong screws might
damage the unit.
Hook on the top side
Bend the appropriate tabs to hold
the sleeve firmly in place.
How to remove the unit
Do the required wiring.
( 24)
Dashboard of
your car
23
ENGLISH